Model Car Pedestal
Print Profile(1)
Description
Looking for a display stand for your model cars? Want to show them off at an angle to admire the curves of your vehicles? This model is perfect for you. Measurements: 5.5 cm x 10.5 cm x 2 cm (highest part).
Simple to print; it consists of three parts:
-the inclined support, to be printed vertically for best results;
-the road, to be printed face down on a textured plate for an asphalt effect; after printing, it should be glued onto the downhill road, ensuring good adhesion to all corners.
-a small corner to glue onto the road to keep the car tilted at the desired angle.
Suitable for most 1:43 scale model cars.
The label can also be placed on the shorter side, inside a triangular groove.
A printing project of about 1 hour and 32g of filament. Excellent with AMS, but if you don't have AMS, you can also print only the downhill support: with the car displayed, the lack of the road above will not be noticeable.
The white stripes on the road are slightly raised to give the effect of paint on asphalt!!!
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (2)