Korg Volca Series Honeycomb Stand - Free 3D Print Model

Search models, users, collections, and posts

Jackalolz

Hobby & DIY>Music

IP Report

Print Profile(2)

All

P1S

P1P

X1 Carbon

X1E

H2D

H2D Pro

H2S

P2S

H2C

X2D

A2L

A1 mini

Both Prints; 0.2mm layer, 2 walls, 15% infill

Designer

1.8 h

1 plate

5.0(6)

Single Prints: 0.2mm layer, 2 walls, 15% infill

Designer

2.2 h

2 plates

5.0(2)

Open in Bambu Studio

Boost

111

Released

Description

A snug honeycomb stands for the Korg Volca Range. The print fits like a dream and can be placed anywhere between the rubber feet. The Volca sits at a 50-degree angle and sits 20mm above the ground for cable clearance typically found with DAW-less setups.

Assembly:
Printed supports are not necessary. To attach the stands, seat the bottom of the unit in the honeycomb stand with the top of the stand bending over the top. Due to its flexible nature, the stand can fit without the clips breaking.

Notes:
This was printed with the standard 15% infill which results in the stand being easily movable due to its lightweight nature. A possible fix would be increasing the infill percentage but the stand may still be light for aggressive tabletop use.

The same stand structure is available in the Korg NTS-1 & Korg NTS-2 Oscilloscope. This stand is also available with an extended base to accompany an Arturia Keystep.