Wall lamp modular - lampshade changable in seconds

Modular wall lamp system, which allows for no-tool changing of the lampshade in seconds! All parts print without support.

The wall lamp system consists out of 2 components:

• the base: 17.4 cm wide x 2.3 cm high x 1.66 cm deep. The base can be attached to a wall with either screws (there are 2 screw holes) or with double sided tape. In the pictures, I attached the base to the wall using double sided tape.
• the lampshade:  two models are provided in the 3mf file.
  • a square lampshade: the dimensions are 20 cm x 20 cm x 20 cm. This lampshade would also be deep enough to use on most E27 lamp sockets.
  • a rounded lampshade: the dimensions are 20 cm x 20 cm x 12 cm (deep). This lampshade is perfect to use with a Bambu Led 001 kit, and may fit for some E27 sockets, but I recommend you double check the depth first.
  • other lampshades may be added in the future :)

As is shown in the movie, it is very easy to change the lampshade. The vertical bar at the back of a lampshade slides into the base and by pushing the lampshade up, it slides out. Changes lampshades is literally a matter of seconds.

In the pictures, I used the Bambu Led 001 kit, but the lampshades will also work for other lighting sources, likes E27 lamp sockets. Please make sure you are using LED lighting, not old-school incandescent bulbs, since LED lighting barely produces any heat.

It is recommend to print all models with a brim of 5 mm to ensure that they are properly stuck to the print plate. Particularly for the high lampshades this is highly recommended.