A1 / A1 mini Chainless Cable Organizer 1.0 All-New Original Design

Original model! No splicing! No secondary creation! No plagiarism!

This is an accessory for the Five-Way Protection Bracket. Please be sure to print the Five-Way Protection Bracket before assembling this accessory.

When installing, be sure to check if the cable is tangled or bent. If the right-side cable bends when moving the toolhead left and right, you need to move the toolhead to the far left, manually straighten the cable, and let it rest overnight.

If you find the cable has aged and become too soft, you can reinforce it by wrapping it with Teflon film tape, which also increases lubrication. (Applying Teflon tape inside the conduit and wrapping the cable with Teflon film tape is to reinforce the soft cable, ensure smooth movement, and avoid wear and tear.)

The model has been printed and tested successfully, no need to repair the model.

It is recommended to perform printer and filament calibration before printing.

If print shrinkage is severe, it is recommended to measure the filament shrinkage rate.

To reduce friction, I applied Teflon tape inside the guiding sleeve. If you are still concerned about cable wear, you can also apply Teflon film tape to the right half of the cable. (To apply, remove one end of the data cable, then straighten the cable. The film tape should be parallel to the cable, applied as one continuous piece from beginning to end, sticking the top surface first then the bottom surface. Spiral winding is not recommended, as it can cause obstruction due to tape thickness.)

Matching filament