Super Mario Marble Run Puzzle 70g Toy Compatible with Official 6mm Marbles No AMS Required
Print Profile(2)
Description
Mario Marble Run
Boost Me (for free)
If you enjoy this, your support is appreciated
I Introduction
This model is a Mario marble run, no AMS required, single-color printing is sufficient, compatible with official marbles 【6mm diameter】7mm or 8mm may be勉强适配
Filament required is approximately 70g
It can be displayed upright, conveniently storing the marbles
II Assembly Instructions
Tools required include 502 glue
1. Press the spring into the frame until it reaches the bottom.
2. Using 502 glue, apply it to both sides, 【Do not apply it to the spring launcher】, then cover it. I used transparent filament; the file shows white filament.
3. Insert into the box. The box features a secure snap-fit design. If you prefer easier opening, you can sand down the protrusions on the sides of the box.
4. Apply 502 glue to the flag and place it in its corresponding position.
5. Fit each small part into its designated recess. The design makes it easy to locate the correct positions.
6. Install the pipe on the wall, then carefully insert it into its position using 502 glue. Patience is key.
7. Insert the official 6mm diameter marbles (7mm or 8mm may also fit). Pull the spring launcher to launch.
8. Finally, store the marbles when not in use. Have fun assembling!
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (1)