Balloon Inflator V2 - Fast Print - Without Support - Free 3D Print Model

Search models, users, collections, and posts

Remixed by

ValMadiaz

Toys & Games>Other Toys & Games

IP Report

Print Profile(1)

All

P1S

X1 Carbon

X1E

H2D

P1P

A1 mini

H2D Pro

H2S

P2S

H2C

X2D

A2L

Original Profile

Designer

20 min

1 plate

4.7(32)

Open in Bambu Studio

Boost

139

380

560

371

Released

Description

Inflation Aid Version 2

This is a quickly printed inflation aid for balloons.

Key Changes:

Improved Strength
Less Filament
Faster Print

Post-processing option: If print quality varies, the sealing might not be perfect. The internal surfaces can be smoothed using a flathead screwdriver, knife or key by gently rotating the inner part.

Functionality: Ensures a tight seal for reliable use during inflation.

Compatible with Balloon Hover Disc:

https://makerworld.com/de/models/1067163#profileId-1056392

Boost Me (for free)

If you enjoy this model, please consider leaving a Like and sharing your creations. Thank you for your support!

Documentation (1)

Assembly Guide (1)

Post-Processing Guide.pdf

Comment & Rating (48)

@bob69

I misuse it a bit. :D Inverted the flow direction and using as a mouth pice on top of a straw, to easier suck out the air of a vacuum frezer bag. Works great!

@SliQ

Print Profile

Original Profile

ok:)

@DextersWerkBank

Print Profile

Original Profile

it worked, and like the creator shared, it needed little turning before it could make a seal. And works well 😁 I added a 20mm extension to the original dimensions towards the inlet side with reduced OD to use it with a 9mm PET Tubing..

@Supermcghie

Print Profile

Original Profile

Worked great. A little hard to blow in, but it’s because there’s a good seal and you’re getting back pressure. Great design

@Calok

Print Profile

Original Profile

scaled it from 18% to 9% and added a 2mm brim, still printed great!

The profile uploader has replied

@user_819784966

Very nice! For which use case did you scale it?

@Calok

Replying to @user_819784966 :

wanted to see if the concept worked but was low on filament, scaling went from ~5g to ~1g. also have a tube that is the same diameter as the 9% scale

@user_4005169457

could you send me that print file?

@user_4005169457

how long will the balloon stay inflated? I feel a very very slow leak. I’ve twisted it a lot

The designer has replied

@user_819784966

Thank you for your comment. This is an inflation add. To make sure the balloon holds air permanently, you need to tie a tight knot at the end. Without a knot it depense on the print quality and size of the balloon how long it will take until the balloon is airless again. I have never tested it but would guess 60min.

(Edited)