Search models, users, collections, and posts
Lithophane "The Rut"
IP Report
This model is created by Lithophane Maker
Make Your Model
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
4.2 h
1 plate
Open in Bambu Studio
Boost
5
3
0
0
4
2
Released
Description
I personally Photographed these deer a couple years ago while I was Backpacking the mountains of Montana, right at the early days of the rut these two were back and fourth for over a hour! Lucky me i was able to get a ton of really good photos of this buck in return. I hope you enjoy!
Print settings:
.12 layer
.15 initial layer
3 top shells
3 bottom shells
100% infill
Happy Printing!
License
This user content is licensed under a
Creative Commons Attribution
Comment & Rating (0)