Kamen Rider Ryuki/Dragon Knight Advent Deck

This is a model for making Kamen Rider Ryuki/Other Rider Card Advent Deck. 

The model has a spring bed and uses filament as the hinge. I also provide a no spring bed if anyone is interested.

 ̶S̶p̶r̶i̶n̶g̶ ̶t̶y̶p̶e̶ ̶t̶h̶a̶t̶ ̶I̶ ̶u̶s̶e̶:̶ ̶C̶o̶m̶p̶r̶e̶s̶s̶i̶o̶n̶ ̶S̶p̶r̶i̶n̶g̶
̶W̶i̶r̶e̶ ̶T̶h̶i̶c̶k̶n̶e̶s̶s̶:̶ ̶0̶.̶8̶m̶m̶
̶L̶e̶n̶g̶t̶h̶:̶ ̶5̶m̶m̶
̶O̶u̶t̶e̶r̶ ̶D̶i̶a̶m̶e̶t̶e̶r̶:̶ ̶5̶m̶m̶

**refer notes below

**If you can find softer spring, please use that instead, softer spring is better than hard one in this case.

You will also need to prepare a 5sec glue to stick some part of the model.

I also provide a blank design for you to customize for other rider/any other logo design.

V2

• Added various other rider deck design.
• Slight changes made to the design of the deck.

I also have better experience when using the spring below:
Wire Thickness: 0.4mm
Length: 5mm
Outer Diameter: 5mm

This spring provide just enough spring strength to push to card upward without messing with the superglue used on the deck.

I have a video made for the assemble guidance. Thank you for your support.