Search models, users, collections, and posts
TrimUI Brick Dock
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
2.2 h
1 plate
Open in Bambu Studio
Boost
3
9
2
1
14
12
Released
Description
MUST PRINT WITH SUPPORTS
This dock was designed specifically to fit the TrimUI Brick with the grip designed by r_mix, the link to the grip is included below:
https://makerworld.com/en/models/879491-trimui-brick-grip#profileId-833317
It does however fit just the Brick quite well! The print will turn out just slightly different than the images provided as I removed some of the holes to make removing supports easier.
I would heavily recommend pliers to remove the supports as they can be a bit tricky to remove.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (2)