Looted

cover

Graded Card Slab Protector Back Plate Image 1.png

Graded Card Slab Protector Front Plate Image 2.png

IMG_8880.jpg

IMG_8881.jpg

IMG_8882.jpg

IMG_8884.jpg

IMG_8887.png

CGC Graded Card Slab Bumper

IMG_8906.jpg

CGC Slab Bumper

IMG_8968.jpg

IMG_8967.jpg

IMG_8964.jpg

IMG_8965.jpg

IMG_8966.jpg

TrimUI Brick Dock

Printed with Overture 95A TPU

Great print, significantly minimizes the rattling of the printer. However, I had dried my TPU for a full 8 hours before the print and still encountered quite a bit of stringing (didnt effect the useability of the print so completely fine). Think it probably was still a bit too wet, but wanted to share in case other's experienced the same issue with the print profile.

K-Studio.ca

A1 Mini Anti-Vibration Pads

Standard Profile for TPU Only

Great little model. Would highly recommend printing with a 0.2mm nozzle instead of 0.4mm as some areas that are connected to supports look a bit messy. 

D-studio

Cute Big Daddy from BioShock

0.2mm layer, 2 walls, 15% infill

Earn this badge when visit MakerWorld more than 20 days in last 30days UTC time

MakerWorld Guardian