Crash Bandicoot Bonus platform Maglev kit

Introduction:

This bonus platform is actually floating in mid-air Thanks to the power of magnets!!! 
Made for Mr Bandicoot to transport it safely to new challenges :)

Printing details:

Layer height: 0.04 mm to 0.16 mm, depending on the part

Material: PLA-Wood, PETG

Supports: None

Print time: 10 hours total for all parts

Filament consumption: 95 grams TOTAL including waste

5 COLORS on 1 AMS-LITE:

Since I only have one AMS-lite per printer, START PLATE 1 with WHITE filament loaded into the yellow slot THEN switch that white to yellow when it pauses (I already set up the pause one plate 1).  If you have a 5-colour-capable printer, skip this step, only print plate 4 for the platform top and discard ignore plate 1.

Parts required:

Please check out the BOM with links at the bottom of this page.

Assembly and USAGE instructions: (feel free to use the video playback speed option if it's too slow or too fast to follow instructions)

Additional models of mine to complete the Bandicoot family:

Crash Bandicoot: https://makerworld.com/en/models/556499-low-poly-retro-crash-figure
Wood crates: https://makerworld.com/en/models/1023362

Aku and crash crates: https://makerworld.com/en/models/1023413

His best frenemy Mr Cortex: https://makerworld.com/en/models/684949

TNT Crate: https://makerworld.com/en/models/594097

NITRO Crate: https://makerworld.com/en/models/594116

His best scaley friend Mr Spyro: https://makerworld.com/en/models/1015786

And his best furry friend Mr polar bear cub: https://makerworld.com/en/models/605606

If you print them all send me a pic!