Sailboat Series - Cutter (Remastered)

A more detailed model of the cutter -- build new from the ground up -- that is fully 3d printable.

(Build guide see below)

It features: 

• a redesigned and more realistic hull 
• better rigging that is easier to place
• less brittle parts
• improved sails
• more details
• a stand, so it doesn´t capsize that easily anymore

Suggestions before printing:

• have a way to remove small and thin parts (~0.2mm) from the build plate, e.g. a scraper

Build guide:

• print the parts :) 

Step 1: 

• Remove the supports 

  The parts should no longer easily break, however still be careful, especially with the bell

   

Step 2 (optional but recommended):

• Organize the parts 

  

Step 3:

• Connect the rudder to the hull 

  (It might be a tight fit but should work)

  

• Connect the rudder and hull with the c-shaped rigging / connector pieces

  

• Put the rudder handle on top of the rudder 

Step 4:

• Connect the first (bigger triange) sail to the bowsprit. I suggest using the second hole from the front and back.

  

• Connect the second (smaller triangle) sail to the bowsprit. 

  

Step 5:

• Build the main mast

  

Step 6: 

For connecting the square sails use the outer holes on top and the inner on the bottom side

• Connect the moonsail (top) to the main mast. 

  

Step 7:

• Connect the main sail

  

Step 8:

• Place the mast-connector on the mast (as shown in the picture).

  

Step 9:

• Put the masts together and connect the 2nd square sail 

  

Step 10:

• Connect the topsail to the mast

  

Step 11:

• Put the mast on the hull

Step 12:

• Cut a piece of rigging and pull it trough the bell

  

• Place the bell on the hull

  

Step 13:

• Place the cover on the cargo-hold

  

Step 14 (optional but makes it easier to position the bowsprit):

• Cut the back rope that connects the front sails as pictures (after bending them so they don't slip out)

  

• Place the bowsprit on the hull
• Pull the remaining rope of the front sails trough the designated holes (so that the bowsprit isn't lifted but doesn't fall either)

• Bend the rope and cut off surplus 

  

Step 15:

• Pull a line trough the anchor and fix it to the hull

  

Step 16: 

• Put together the 2 cannon pieces and place them on the hull 

  

Step 17: 

• Place the lifeboat onboard

Step 18: 

• Connect the side rigging

  

Step 18: 

• Put the sing on the back 

  

Step 19 (suggested):

• try to not get frustrated if the small pieces don't stay in place

Step 20:

• Place the cutter on the stand