Search models, users, collections, and posts
TP-link EAP 6 series vertical stand
IP Report
Print Profile(1)
0.25mm layer, 3 walls, 25% infill
Designer
1.8 h
1 plate
Open in Bambu Studio
Boost
44
152
18
7
274
179
Released
Description
I was inspired by a similar model, but I wanted mine to be more rounded, lower, and with smaller front arms—so I designed my own stand from scratch.
Finished off with a colorful Omada logo on the back, just for that extra bit of swagger. 😎
Printed with PETG from Devil Design (white + dark grey). This material can handle flow rates over 20 mm³/s, so the print time is around 1.5 hours. For compatibility, the published model is set to Generic PETG.
The rear mounting holes are spaced 50 mm apart, with a 4 mm diameter. If your access point came with the same mounting plate as mine, use the "A" holes. The top section includes a 3 mm recess to help reduce heat transfer from the metal mounting plate to the printed model.
License
This user content is licensed under a
Creative Commons Attribution-Share Alike
Comment & Rating (18)