Autodarts Camera Mounts for Target Corona Light
Print Profile(1)
Description
Mounting the camera and the lid require M2x6mm screws. Requirements per mount are 4 for the camera and 2 for the cover. The end fits in the groove of the light. Slide it in vertically and rotate it forward to snap it in. I've only tested this with PLA but it should also work with PETG. Not sure about other filaments.
The print profile has updated support settings for easy to remove supports. Be careful when removing the supports, especially the ones for the wire guides. You may break off the wire guides with the support.
Any suggestions for improvements are welcomed!
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (46)