Nitecore TINI2 Watchband Case

This is a remix of a remix of Nitecore TINI2 case that's been modified to fit on a watchband.

WARNING: This case has a very tight tolerance and your TINI2 will fit very snug inside. Once the TINI2 is in the case, it'll be very difficult to remove without destroying the case.

The OLED screen, buttons and USB-C charging port are all accessible without taking the flashlight out of the case.

It should be printed on the flat side using layer pattern type that affords the most strength. For my A1, I used ASA with settings on 0.20mm Strength, concentric top/bottom/infill pattern, and organic supports. That stiffened up the bridge on the slot where the watchband goes through. When I printed it on the tall side, the bridge just snapped along one of the layer lines.

The watchband should be no thicker than 2mm and no wider than 24mm, perfect for NATO-style watch straps.