Search models, users, collections, and posts
RatRig VCore 4 Toolhead Fan Mod
Remixed by
IP Report
Print Profile(1)
0.2mm layer, 4 walls, 15% infill
Designer
1.4 h
1 plate
Open in Bambu Studio
Boost
1
2
0
0
4
1
Released
Description
The original design left the wires for the Beacon dangling below the toolhead. Occasionally the wires would snag on a bad print. This modification simply increased the depth of the channel and adds slots for zip ties, so the wires are now flush with the bottom of the toolhead. The channel depth was increased 1mm so I doubt it will cause any airflow problems, but I haven't verified that.
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial
Comment & Rating (0)