SureFeed Mircrochip Pet Feeder Back/Rear Cover

I HAVE A NEW VERSION THAT'S MUCH EASIER TO PRINT AND INSTALL! YOU CAN FIND IT HERE.

Back Cover / Rear Cover for Sure Feed Microchip Pet Feeder!

I paid $165 for a feeder that's heavily patent guarded. I'm not paying another $38 for a piece of plastic. 

Thus, I made my own. It covers the entirety of the back while the lid is open, and the lid itself will cover the rest, which also makes it easy for you to observe how much food is left and how your pets are doing while they are eating.

Some notes before printing:

• I strongly suggest using PETG, since it's more flexiable and a lot easiter to be clipped into the feeder. The picture above shows two PLA and one PETG translucent. 
• The back of the cover that faces outwards is the first layer being printed, so the back texture completely depends on your print plate.
• Since it's a huge print that covers a lot of ground, warping on the corner is very likely, so I strongly suggest you print in a warmer climate.
• Also because the support might be unstable later into the print, I enabled a huge brim as well. If you deem this unnecessary you can remove it yourself.