Search models, users, collections, and posts
Print-in-Place CR2477 Battery Case
Remixed by
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
38 min
1 plate
Open in Bambu Studio
Boost
26
60
22
9
167
81
Released
Description
Model
Print-in-place model to hold CR2477 Batteries.
Print instructions:
0.2 or less layer height. No supports needed.
The hinge for this box is print-in-place. I used a 0.2mm clearance which should be fine for most well-calibrated printers. The first time you move the hinge may require a bit of pressure. Repeatedly opening and closing the box will make the hinge movement smoother.
Same goes for the clasp, which may be a bit hard to open the first couple of times. Open and close it a few times, and it should be fine.
This remix is based on
This source model was used for remixing/sharing before its license was restricted.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial
Comment & Rating (22)