Solder Spool Holder - Simple
Print Profile(2)
Description
Boost Me (for free)
Feel free to boost me if you like the model.
Simple solder spool holder for the standard 54x57mm spool.
No support needed.
No glue needed.
Please assemble after printed. Insert the sides into the groves on the base.
Slide it at an angle until you reach the bottom. Tilt it into the slot and push in or tap it in. It will lock pretty tight.
Make sure the spindle indentations are to the rear.
Assemble the spindle rod together with the PEM in the middle. It should fit pretty tight so no glue is needed.
Insert it into your solder spool and drop it into the assembled base and run the solder wire through the solder guide's hole.
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (36)