Search models, users, collections, and posts
Print Profile(4)
0.1mm layer, with brim
Designer
1.1 h
1 plate
1 hour print (0.1mm layer height, 100% infill)
Designer
1.1 h
1 plate
Fuzzy Skin GripTape, Wheel Holes, 0.1mm, 17walls, 10%infill
2.7 h
2 plates
Removable Wheels if broken, 0.1mm layer, 17walls, 10% infill
2 h
4 plates
Open in Bambu Studio
Boost
1212
2373
372
45
6.1 k
3.7 k
Released
Description
Fully functional print in place mini skateboard. Print it with solid infill to make sure it's strong enough or use the provided print profile. The wheels are fully functional and turn. Do make sure you use a low layer height (I recommend 0.1 or 0.08mm) for better overhangs near the build plate, Also I noticed that the wheels might get stuck if you use higher layer heights.
Made this because I wasn't happy with the existing Tech Deck models online.
You might not need a brim. I printed this on my Bambulab A1 and didn't need a brim, your mileage may vary.
EDIT: I added a print profile with a brim. If you have issues with bed adhesion pick the new print profile with a brim!
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (372)