Cake Pop Disc Tool Egg Shaped

An egg shaped cake pop disc tool. 

Sizes:
Small (Approximately 44mm)
Large (Approximately 60mm)

Instructions: 
1. Place the smaller solid part into the hollow part (as pictured). 
2. Place onto the spread out cake mix

3. Press it down on the tabs

4. Lift the tool up and push the solid part in to pop the cake shape out

5. Repeat

Care Instructions:

Since this is 3D printed please make sure you adequately clean and dry by hand after use to reduce bacteria/germs.

See all my cake pop disc tools here: https://makerworld.com/en/collections/7337553-cake-pop-disc-tools

Pictures: I love seeing pictures of your final prints from my design (genuinely).  If you are doing cake pops I love seeing the final cake pops also!

Design requests: If you have a design request feel free to send me a message regarding it and if it's something I can do I will give it a try!

Ratings: If you rate less than a 5 star rating please provide detailed reason as to what the issue is and pictures if possible.  I'm always looking to improve designs but can't do so without feedback.  Please make sure the issue isn't related to your specific setup/filament and keep in mind silk filament tends to be weak.

Please boost!! Boosting my designs helps me fund my hobby and keeps the designs coming!  Thank you to all that provide boosts!

Selling: If you would like to sell prints of my designs please please subscribe to my membership.  I think I have the memberships priced affordably for most people and the funds help me continue my hobby and cover filament/maintenance.  Thank you for those who subscribe and don't steal the designs.