Search models, users, collections, and posts
120mm sturdy fan covers
IP Report
Print Profile(1)
0.2mm layer, 6 walls, 100% infill
Designer
3.1 h
1 plate
Open in Bambu Studio
Boost
48
134
7
1
200
57
Released
Bill of Materials
Bambu Filaments
Select all
Description
For one project needed a very sturdy fan protection that will connect 2 120mm fans and make a brick from those, so i made this.
Be aware that there could be some friction-spacing problems, and the connection could be not ideal.
Made this for id-cooling fans and they fit not perfectly, but some noname ones fit perfectly, so that really depends on some mm from time to time, but you will have an opportunity to use some force and everything will be ok.
Cover for one fan is not tested and made just cause i had time.
I printed the first level with only one wall and very low speed, it was easier for me.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (7)