Search models, users, collections, and posts
VelocityOne Shaft Stab Yoke Fix
Remixed by
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
1.4 h
1 plate
Open in Bambu Studio
Boost
12
37
4
0
37
20
Released
Description
It is a remix of the shaft created by "Rhinez" on Thingiverse.
The bearings used are the same as those found in 3D printers like Anycubic or Creality.
The screws used to secure these bearings are M5 (the holes have a precise diameter, so nuts are not needed).
Finally, the screws and nuts used to attach the two pieces to the Yoke are M4.
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (4)