DJI Mavic Air 2 Mobile Phone Mount (Regular and Large)

This is a remix of Helichrissi's Mavic Air 2 phone holder design. My goal for this remix was to make the holder a little more sturdy by adding more screws. I also wanted to create one that was slightly larger to accommodate my phone with an Otterbox case. I added four screws to attach the lower part of the holder to the base and also added a center screw to attach a clamp to keep the base from slipping off the controller. Finally, I designed a thumbscrew to allow for toolless assembly and disassembly of the mount.

What to Print

• 1 -Base
• 1 - Holder Bottom (either regular or large but not both)
• 1 - Adjustable Slider (either regular or large but not both)
• 1 - Clamp
• 2 -Thumb Screw

Additional Supplies Needed

• 4 - M3 x 12MM Socket Head Cap Screws
• 4 - M3 Nuts
• 1 - M4 x 30MM Socket Head Cap Screws
• 4 - M4 Nuts

Print Settings

Printer Brand: Creality

Printer: CR10S PRO

Rafts: Doesn't Matter

Supports: Yes

Resolution: 0.2

Infill: 30%

Filament: Hatchbox PLA Grey

Notes:

I used rafts because I was getting some warping on the larger parts; however, they may not be required if you have a different setup.

Category: R/C Vehicles