DeepCool CH160 side panel replacement

I replaced DeepCool CH160 glass panel with this design which replicates the 3.5mm squares on the rest of the PC case. I printed this on BL P1S and split the print down the center as it's 330mm long. I added butterfly clips which are used to keep the two panels joined on the inside of the panel with some glue. It seems solid enough. This design has large pill shaped air vents at the bottom of the panel which helps the video card push out some of the hot air. There are two clips on the right hand side of the panel which need to be bent with a little bit of heat - I used a hair drier. If you look at your existing glass panel, it needs to basically match the same bend which is about 2.5 mm high.  I did upload a close up photo of one of the bent clips.