RPi 5 GeekWorm Prototype for testing

A slightly tight fit. With gentle persuasion, the Pi5 fits well. The screws for the X1015 are too short for fixing from below. I will have to find other screws. For the next model, it would be beneficial to incorporate a small recess to conceal the screws. This would create a surface that doesn't rest on the screws. I printed the lid twice thinking it would be the same for the bottom. This is not the case (but it's my fault, I should have looked more carefully). The entire Raspberry kit must be disassembled. Otherwise, it's impossible to fit. Steps: - Attach the fan - Secure the ribbon cable to the Pi5 - Insert the Pi5 into the case - Attach the brass supports to the X1015 board - Insert the X1015 board above the Pi5 - Insert the ribbon cable into the X1015 - Screw from below. - Attach the lid. Note: I would appreciate a bottom lid. I don't particularly like seeing the exposed electronics. Thank you for this object