Ford Kuga DM2 trunk fitting piece (Full version)

German:

Adapter piece to raise the floor in the boot of the Ford Kuga DM2 (possibly other model series) from 2012 to 2019
It is typically made of styrofoam However, since the Kuga's facelift, this component is no longer included

As the entire component exceeds 30cm in height, I have divided it into two parts These can be easily and securely joined after printing via the dovetail joint

English:

Adapter piece to raise the boot floor of the Ford Kuga DM2 (and potentially other models) from 2012 to 2019
Traditionally constructed from styrofoam, this part is omitted in post-facelift models

Given the component's height exceeds 30cm, it has been segmented into two parts These seamlessly and securely interlock post-printing via a dovetail joint

Print Settings:

Printer Brand: Anycubic

Printer: Semi-closed 4Max

Rafts: No

Supports: No

Resolution: 200

Infill: 15

Notes:

Remember that PLA should only be used within a specific temperature range
I have used these adapters in my car for six years, including very hot summers, without experiencing any deformation issues