Jewellery Foldable Box / Screw Organizer

Hello !

Here is an organizer that you can use as you wish. It can be a storage for your everyday jewelry, or you can use it as a container for screws, nuts, washers, or magnets. Put whatever you like in it.

The dimensions are:

• Total height 36mm
• Height of a single tier 18mm
• Total width 86mm
• Total length 176mm

The model was printed by using esun PLA+. If you want you can use petg or abs

Assembly Instructions

The entire assembly process is very simple:

1. Insert the axle through the hole in the connector.

2. Pass the axle with the connector through the hole in the side wall of the lower part of the organizer.

3. Repeat steps 1 and 2 for the adjacent hole in the side wall of the lower part of the organizer.

4. Once both ends of the axle are visible on the inner side of the organizer wall, secure them using the spacer – this is the flat piece with two holes. Make sure it is properly installed by pressing it down with your fingernail over the axle ends.

5. Repeat the above steps for the opposite side.

6. Once all four connectors are in place, simply place the top tray on the prepared lower part.

7. Lift the connectors so that the holes in the wall and the connectors align, then insert the axles.

8. Finally, secure them again as described in step 4.