Cardcaptor Sakura Three-in-one Wand

1.The bird-head staff has been modified with threads and separated into components

2.The star staff has been modified with threads, its wings have been re-separated, and the golden adornment beneath the circle has been redesigned

3.The transparent staff has been modified with threads, the connection method of its upper half has been redesigned, pegs have been added, the wings have been modified, and the wings and pegs have been separated

4.Threads have been added to the end piece

The above models have been combined into a three-in-one set, uniformly compatible with the same type of threaded rod, meaning only one rod needs to be printed to connect three different models

Assembly Recommendations (Hot melt adhesive is prone to failure and is not recommended❌. Ignoring assembly recommendations is at your own risk, it's a waste of materials.)

①It is recommended to sand the bonding surfaces and use two-part epoxy resin (AB adhesive) before bonding the bird-head staff main body and its two wings.【I made three staffs myself and found that hot melt adhesive bonding is easily prone to failure, and because the surface is slightly curved, 502 adhesive cannot be used. After testing, I found that sanding the surface and then using AB adhesive for bonding is more secure】

②It is recommended to use two-part epoxy resin (AB adhesive) when bonding the star staff main body and its two wings

③It is recommended to use hot melt adhesive or two-part epoxy resin (AB adhesive) when bonding the wings of the transparent staff

Printing Precautions！！！！！！Ignoring precautions, blaming me for failed prints is unproductive.

p1: All plates have been successfully printed three times on a P1S (no adhesive was used, only dish soap was used to clean the build plate), however, it is still recommended to clean the build plate and apply adhesive before printing the rod and the transparent staff wings (large white wings), increasing the model brim if necessary

a1 (not recommended for printing): I am unsure if the A-series can successfully print this model. Comments suggest that the rod and wing parts are prone to stringing on A-series printers. It is recommended to add thin, tall support pillars, however I do not own an A-series printer and cannot test this. I am looking forward to A-series users refining the settings and uploading print parameters

I support the commercial use of models sourced from makerworld by 画清池夏, provided the price is reasonable (＜0.18/g), no authorization is needed

Other commercial activities are not supported. Videos featuring this model must include a screenshot of my makerworld page and tag my Xiaohongshu/Douyin account, thank you for your cooperation