Omnipod Cover

This Remix of the omnipod cover allows printing in PLA as well as greatly reduces the appearance of layer lines. Others i found online require you to print in other orientations as well as TPU. There is a small amount of layer lines on the bottom where the supports however they can be less noticable if you are willing to take the time to sand and clean up. Photos of this have been added to show this issue.

This remix also allows you to effectly decorate the cover to make it that little bit more personal. My Wife is type 1 diabetic and loves being able to create her own designs to match her outfits (iver printed loads of these).

The original file is a little bit too tight which i have increased by 1% in order to make putting on and taking off a little easier.

Full credit of this model goes to the original designer but this remix has been made to share the love that little bit further.