Cribbage Board - Free 3D Print Model

Search models, users, collections, and posts

Remixed by

Stokelton

Toys & Games>Board Games

IP Report

Print Profile(1)

All

P1S

P1P

X1 Carbon

X1E

H2D

H2D Pro

H2S

P2S

H2C

X2D

A2L

0.2mm layer, 2 walls, 15% infill

Designer

8.4 h

1 plate

4.6(9)

Open in Bambu Studio

Boost

147

279

154

Released

Description

Travel cribbage board based on https://makerworld.com/en/models/578508#profileId-499233, changes made…

Removed a set of the holes to make 2 runs only
made the top of the board flush for easier viewing
added colours to holes and the top of the board

Comment & Rating (21)

@user_4258148866

The print profile is no longer public

NO PAUSE FOR MAGNET INSERTION. Black and red visible through the white layer. Will likely reprint an alternative option.

The profile uploader has replied

@stokelton

Hi, I'm very sorry the print didn't work as expected I have never tested the print myself... I will remove the print profile as it isn't fit for purpose.

@user_391124174

Boosted

i love the flush design but is there a way you could load it also with the 3 runs

The designer has replied

@stokelton

Thanks! I have just uploaded a new print profile for the 3rd run, haven't print tested so let me know if there are any issues printing!

@rbowman1234

Boosted

Print Profile

0.2mm layer, 2 walls, 15% infill

Good design, missing game counter and starting (non point) peg holes, as well as skunk/double skunk lines

@Steve_Roulet

Print Profile

0.2mm layer, 2 walls, 15% infill

Good print but no pause to insert magnets, I paused print on layer 72 inserted magnets and all was fine. No game counter holes otherwise perfect.

(Edited)

Other Issues:No pause (layer 72) must be added to print profile. No game counter holes,

@user_1621252883

We did not see the numbers on the board when we loaded it into our slicer. We have not printed it since the numbers are useful.

@user_1399778582

Boosted

Would love it if the three-run model would use a separate color for the third route.

@user_4107556699

Print Profile

0.2mm layer, 2 walls, 15% infill

perfect for travel

Show original

@user_2565494821

Print Profile

0.2mm layer, 2 walls, 15% infill

(Edited)

The profile uploader has replied

@stokelton

thanks for the review, can I ask why the low rating? are there any issues I should be aware of?

@user_2565494821

Replying to @stokelton :

It was a petty review moment on my part. the print's hinge errored I don't know if it was my printer or the file, but it didn't fold. the hinge fused and this caused the board to snap. I was frustrated at the waste of filament and thus my poor review. in retrospect that wasn't your fault thus the edited review.