Fire Phoenix Ornament, TV Mount with Stand (Sliced)

The wings, body, and talons have been segmented, significantly improving the success rate of flawlessly removing supports. Adhesive bonding is required; avoid mortise and tenon joints, as they compromise the smoothness of the bonding surface.

The phoenix's intrinsic flames are intended for subsequent hand-painting (Aobirdagawa metallic red).

A television stand for the phoenix has been incorporated, enabling placement atop a television set.

The stand comprises two sections. The lower section utilizes television-colored PETG, while the upper section matches the phoenix's PLA coloration. The two sections are linked via a sliding mechanism for convenient assembly and disassembly.

The lower stand section is designed for televisions 18mm in thickness. To adapt to your television's dimensions, disable "uniform scaling" in your slicing software and adjust only the X-axis.

After completing adjustments, note the scaling factor; it is imperative to apply the identical scaling factor to the "upper section"!

The main body of the upper stand section utilizes 15% infill, while the lateral support bars employ 50% infill. These settings are pre-configured. Use adhesive to bond the parts after printing.

Once the phoenix is mounted on the stand, you can heat the support bars to induce deformation and further secure the phoenix (I did not heat them in the image).

Should your print be successful, I would appreciate an image review and any feedback you may offer. If you enjoyed it, please share and boost; thank you for your support!