Cadre Upcycling Energie drink / Beer can 50cl

This project elevates and decorates your favorite beverage

It offers numerous customization options for broader appeal. Frames can be assembled and adorned with optional colored borders, maintaining visual continuity with the support feet. Wall mounting options are included with various screw types and sizes

• Support feet are available in various widths (10mm, 20mm, 30mm, and 40mm) to ensure stability depending on the number of assembled frames. Frame borders match foot widths for seamless design

• Parts labeled “border finish” provide frame edge finishing options. The solo option is for single frames, while A and B are for multi-frame assemblies. Omitting these pieces creates the look shown below

• 

  Here's how to prepare the can. Caution: Use protective gear to prevent cuts during this process

• You will need scissors, a small precision cutter, a marker, and Blu Tack

• Begin by precisely cutting the can's top and bottom near the change in angle

• 

• 

   

Next, cut the rear middle section with scissors

• 

  Use Blu Tack to secure the can to the table. Also, apply Blu Tack to the stencil edges to prevent slippage

  

  

• A V2 stencil is provided (V1 shown) to address marker slippage issues

• Ensure the stencil is centered on the can. After marking, cut with scissors

  

• Minor edge imperfections may result. Use the back of the precision cutter to flatten and minimize these imperfections, as shown below (left image shows results after using the cutter's back)

  

   

  

• Once complete, insert into the frame. Start by placing it on the left or right side and add the rear support plate. Use your fingers through the plate to secure it properly, as shown

• 

     

  

• Finally, attach the plate supports :)

Feedback for improvements is welcome

Happy printing!

My designs are free for personal use only; resale is prohibited

Licensing for some models will be available soon. Stay tuned 😉