Search models, users, collections, and posts
MXEdge Lift Large Insp. Rock Climbing Crimp Block
IP Report
Print Profile(1)
0.2mm layer, 4 walls, 15% infill, fuzzy skin
Designer
3.4 h
1 plate
Open in Bambu Studio
Boost
89
220
7
7
241
116
Released
Description
This is my attempt at recreating the Lattice Training MXEdge Lift Large.
It features many of the same features and edge sizes including ergonomic 22, 16, and 12mm edges, a 28mm mono, and 120/74mm pinches.
I printed in PETG HF with 4 walls and its holding up great. If using PLA bump it up to 5 walls just to be safe and should be plenty strong enough.
To achieve the fuzzy skin effect on the top surfaces like in the photo you will have to use Orca Slicer and increase the ‘Top Surface Flow Ratio’ up to 2 with the hilbert curve top surface pattern. Teaching Tech has a great video on this and can be worth doing a few test pieces before printing the whole model.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (7)