Search models, users, collections, and posts
Ryobi FVL52 Usb flip light diffuser
Print Profile(2)
0.16mm layer, 2 walls, 10% infill
Designer
36 min
1 plate
0.16mm layer, 1 walls, 10% infill
Designer
22 min
1 plate
Open in Bambu Studio
Boost
5
27
0
1
12
9
Released
Description
I use the Ryobi FVL52 USB flip out light for some fancy B-roll and occasional vlogging and the light while being super bright, is also very harsh. I modeled this diffuser that gets shoved into the light and diffuses but has a small handle on the side so it can be easily removed. I printed with low infills and monoline infill for maximum clear diffusion. You may have to scale up or down a few percentages as PLA seemed to fit just right but I had to experiment with PETG quite a bit to get it to fit right without falling out.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial
Comment & Rating (0)