Search models, users, collections, and posts
Bosch Go Case and Inlay
Remixed by
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 12% infill
Designer
8.3 h
3 plates
Open in Bambu Studio
Boost
11
41
3
1
44
13
Released
Description
Content has been automatically translated.
Bosch Go Professional Case with inlay.
The inlay is based on the model “Bosch Go 2x7” by Willi 3D, and has been modified and adapted for my purposes.
The case accommodates the cordless screwdriver, as well as a total of 24 bits (17 short and 7 long) and the extension.
Unfortunately, in the closed state, the bit extension is slightly too long for the case, so it unfortunately has to be inserted separately. There may also be applications that only require the inlay.
Otherwise, there are certainly a few talented designers among you who can come up with a good solution :-)
This remix is based on
This source model was used for remixing/sharing before its license was restricted.
![[BaBo] insert bosch go 2x7](https://makerworld.bblmw.com/makerworld/model/USb570f20bedc241/design/2024-02-22_qj008l4sxvvp.jpg?x-oss-process=image%2Fresize%2Cw_400%2Fformat%2Cwebp)
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (3)