mr.glubschi

cover

WhatsApp Image 2026-06-10 at 13.58.22.jpeg

plate_1.png

e5aa31233abba77c.jpeg

Empfohlene Druckeinstellungen<ul><li>Schichthöhe: 0.2 mm</li><li>Wände: 3–4</li><li>Infill: ca. 25 %</li><li>Stützen: Nicht erforderlich – das Modell druckt ohne Supports.</li><li>Material: PETG oder ASA empfohlen. Da das Modell langfristig mit Wasser in Kontakt kommt, sollte ein wasserbeständiges Filament verwendet werden (PLA ist dafür nicht geeignet).</li></ul>

Recommended Print Settings<ul><li>Layer height: 0.2 mm</li><li>Walls: 3–4</li><li>Infill: approx. 25%</li><li>Supports: Not required – the model prints with no supports</li><li>Material: PETG or ASA recommended. Since the model will be in contact with water long-term, a water-resistant filament should be used (PLA is not suitable for this)</li></ul>

0.2mm layer, 2 walls, 15% infill

A simple diving spool to screw together. With an elastic rubber band you can attach a loop in the middle hole. With the additional small hole in the wall you can attach the cord to the dive spool.

Print Profile(1)

Description

Comment & Rating (0)

License

Related Models

Diving Spool

Print Profile(1)

Description

Comment & Rating (0)

License

Related Models