printed easy, paused to add BB’s and works great!

easy to print, helps organize my discs without having to mount like other designs

printed well and works great!

pretty cool design, printed and assembled great. I tried printing the grips in TPU90A but had some adhesion problems on the bed, but otherwise clamps down small objects well

printed clean, all of them are pretty useful. one gripe is that when the printer gets hot it tends to soften the little ribs on each hexagon which makes it easier to loosen up and fall off them removing a tool. I’d recommend printed in ABS if you have it. could also be that the wall I printed is in PLa too.

just what I needed to clean up my workbench. clean print profile

printed clean and works great! I decided not to print the outer ones since the two in front and 1 in back are keeping it dry for a while

works great! tried glueing them in but I think the PTFE tubing prevented long term adherence. I also have to take them off on new spools or else it hits the inside of the ams cover. overall, haven’t had any jam or failures due to the feed.

exactly what I needed!

everything printed well, the hole drilling was a bit hard to not hit the case after drilled through, cracked one by accident. might be easier to just upsize the holes in the model

modified the dimensions a bit to fit what I have and added the white trim at the top. looks great and printed well.

Printed cactus in TPU 90A and printed out fairly good after I calibrated, but still a little stringy. I'd recommend increasing the size of the magnets as once you tape it to the wall, the pot tends to shift slightly off making it easier to fall off.

all printed well, holding the tube much better so it doesn’t knock off my LED strip clip holders off during print anymore

just what I wanted! printed well, assembled and installed snugly.

love it, could probably look cleaner with a finer setting or 0.2mm

overall this was just what I was looking for, but the magnets were too small to hold the mount in place when opening and closing the lid. I ended up modifying your design to incorporate 10x2mm magnets instead and now it’s SOLID. I’ll include the remix shortly.

printed clean, mounted very easy. appreciate the inclusion of the magnets on top of the bolt hole so it doesn’t twist UPDATE: I started having AMS 2 pro Slot 3 loading issues. after troubleshooting a bunch of other things, I eventually unmounted the splitter from the mount in picture #3 and the loading issue was resolved. I think the location it’s mounted to makes too sharp of a turn for the PTFE tube which then overloads the AMS feeder, but only for slot #3. So reducing from 5 to 4 stars.

printed well in ABS, no jams yet

came out beautifully! I’m making a handheld pool filter and this caused me to change my design to incorporate because it works so much better than the fine mesh filters online