An excellent model, one that I shall make many of, especially since aliexpress supplied me with 100 perfectly fitting springs. (https://www.aliexpress.com/item/1005007153388789.html) In case anyone else is making these and it's not clear ( the retaining strips should be inserted into a little slot at the edge of the case and bent slightly in the middle so it fits into the other side, no glue required so the hooks can be replaced if they break. I wondered why they were a little longer than the available space. Maybe I need new glasses :) I'm making the longer ones for my usual rigs.

Printed in Matte Black PLA this fits my switch most excellently ! I added an L shaped bracket so I could slip it under the carpet edge and avoid having to drill holes into any furniture.

Having just spilt my tea all over a new reel of PVA tape and ruined it, this is exactly what I needed to print. An excellent design. Although my flask cup was too short (55mm) to sit in it so I reduced the height of the lip to match the rest of the body and re added that nice curved lip onto it, now I can have a warm drink while waiting for the fish to bite without risking ruining anything else when I do get a bite. It also makes a great place to put my phone when the carp bite. Printed in PLA with 100% solid modifiers around the screw areas. P.S. being able to remove the cup holder while packing up is also of great benefit as otherwise sods law says it would get knocked if permanently fitted.