Fit my Snap on spring pin punches after drilling the inside top block on the smallest one. I followed you, please consider reciprocating. :)

they look great I followed you, please consider reciprocating. :)

Love them, they look great on the wife. I followed you, please consider reciprocating. :)

Printed good and looks great, my daughter will love it. Oh yes she did :P I followed you, please consider reciprocating. :)

Turned out great :) I followed you, please consider reciprocating. :)

Too loose of a marry, wouldn't emboss any cards I tried. Nice idea but need tighter tolerances. Printed good.

Worked well but spit in half whilst trying to remove from the mold. Should I use a release spray? Pam?I followed you, please consider reciprocating. :)

Great print but i would sat that the screw should have a wider head, it is too hard to turn once it is flush.

I have printed a ton of different filament clips and THIS is THE best by far, only for Bambu spools though. I followed you, please consider reciprocating. :)

Printed good I cut down the original holder for my Mac picks and fit it inside to make an even better match for them. :)

Fantastic although I did have to strengthen and reinforce where the red and blue meet on the chest piece.

Love the smaller version. printed fine and was great putting it together and seeing what it looks like after done.

Saved having to wait for a spool to come and I like it better what with the end holders situated around the inside.

Absolutely beautiful and printed great. I set my Z distances at .25 and they come of with no damage to the piece.

Turned out awesome, they look real

Printed and looks great. :)

Printed great and fit is spot on. ty :P