Printed full size (unscaled) image. About 4 inches wide. No issues in PLA

Printed in PETG. Fit fine in AMS 2

Printed in PETG. Needed to sand the lids the tiniest bit with 100 grit for an easy fit, but filament used was old and maybe a little wet. Fits inside AMS2 with no issues. Did not use brim.

SUNLU PETG - White Very Loud

Had a difficult time with adhesion on PLA and textured PEI plate (no glue). No adhesion problems with PLA on cryogrip frostbite plate. Also no adhesion problems with PETG on textured PEI plate.

I've been calibrating every new filament with this

SUNLU PETG Elite Series - Black

SUNLU PETG White

PETG with stock PEI Texture plate worked fine. PLA with stock PEI Texture plate failed adhesion, even with increased bed temp, first layer Nozzle temp, and increased first layer height. PLA with Cryogrip Frostbite plate worked fine.