Another great model by The Elemental Brick. Easy to print and assemble.

Amazing model! Shame that I can only give 2 boosts, it deserves more.

I’m not really a cat person (I have two dogs) but I printed these for my mother and my nephew who both have cats. Embrace the multicolours! I also printed extra balls so each toy has three. I had to reduce the size of the balls to 95% for them to move freely throughout the ring. I’m sure the cats will enjoy them.

I haven’t needed it yet (all my refills have slipped right on) but good to have for the day I get a difficult one.

It was too wide to fit my P1S toolbar cover but I reduced the width to 15mm and it works great.

Nice clean print. May scale it up to print again.

Cool little fidget toy

I used this as a starting point. My monitor is on an arm and I wanted my GS5 to sit right below it. That meant raising the GS5 about 70mm off the desk. I started with this to get the angle and foot size, then extended the legs and added a top and bottom plate to give it more stability.

The standard basket seems a bit small but the large is perfect. Nice!

Really nice, I printed a couple of them. I decided it needs a bottom so I printed a 131x5mm disc and glued it on.

Much better than having the poop all over the floor. Printed one for each of my P1S printers. Only nitpick is that the poop doesn’t always slide down the chute very well, but I’m gonna get some Teflon tape to see if that helps.

I haven’t dried any desiccant with it yet, but I’ve printed it and test fit it to my Polydryer. Should make it much easier to renew my desiccant.

Perfect for me since I use my Panda display with two P1S printers. I didn’t want the display to be attached to just one of them. The stand lets me keep the display on my work table.

Really nice, replaced another C110 mount I printed earlier. This one is positioned perfectly and looks like it was meant to be there. No glare at all thanks to the shade. My only wish is that it had a hole to access the SD card

Really nice print. Glued some magnets to the back to put it on my metal front door.

Amazing! Printed one for both of my AMS units. A must have.

Printed 2 for my monitor to display a couple of printed pieces. Very nice, no worries about them falling off. Only nitpick is they could be slightly larger. Update: re-read description and see that it can be scaled up. Will give that a try.

Printed a set for each of my AMSs. Within a few hours, both went from mid 20% to 10% ( as low as the Amazon hygrometers can read). It’s cold and dry here right now, but will become even more important once the summer humidity returns.

Nice! Printed mine in black/purple/orange/white (that’s what was in the AMS 😆). Attached to dishwasher with double sided tape.