Printed perfectly and working great.

Exactly what I needed and also works perfectly for joining Billy with Gnedby

It was a little fragile and a couple of small tabs broke as I was trying to gently put it together. I reprinted the broken parts and I also shaved 2mm off each side of the base at the back to make it slightly narrower so it would fit on an Ikea trolley. The second version printed perfectly and didn't break so I'm going to say the first attempt was my fault :)

It printed perfectly in PLA at 100%. Thanks for creating it!

It's very good - perhaps the hole filling nob could be a little larger or the stand a little wider as for my Playstation it seems a little unstable. It's a very neat solution with the cable wrapped up behind it though.

Works perfectly even for a non-Ikea dish drainer with a similar shape - one set of the corner rail is enough to do the job :)

It works perfectly, prints quickly and the images to show where the little tab goes are very helpful. Thank you!

Thanks! It's the perfect size and holds the watches really well. The bevel on the front is a great idea too.

My desk is much tidier now, thank you! I printed two in red & blue and they were quick and easy!

It's great - just a little too short / light in the front for my Pixel 6a in a case which tips over backwards - it works great in landscape mode though and printed well!