Works as it should and fits snuggly. I printed with silver PLA Silk+ and black PLA Basic.

Printed a few of these from ABS. Looks great and fits the Bambu spools like a glove. Works well either in the AMS or in vacuum bags for storage. I did try with one 3D Jake spool that I happened to have as well, but it has slightly smaller space, so it’s a no go.

Printed with PLA to the diamond effect plate. Fits well and I like this design more than the newer ones with the lid - but that’s just personal preference. I did slow down the initial layer to 20 and initial layer infill to 30, as I usually do with the effect plate to get good adhesion. There was a very small imperfection (due to the adhesion issues with the effect plate, I presume) near where the allen key clip attaches. So I might recommend slowing down the print speed, if you are using a smooth/effect plate.

I printed one of these, but I personally prefer the original better. These do start to screw in slightly better, but I felt these were bit too tight towards the end to my taste.

Excellent design that saves me from buying the 30 € invisible mic cold shoe for my Insta360 X3. Printed with PLA and fits perfectly with Røde Wireless Me. I might consider making the part that attaches to the selfie stick just slightly thinner allowing the the stick to screw a bit further into Insta360 to make the structure more stabile.

Beautiful design that will assure all my patients that Batman is here 🖤💛 Printed with PLA, can fit two cards, but the locking mechanism won’t reach the top one. Although it does stay put just by friction.

Great design! I painted the top of the honeycomb, but probably would have required more than 2 layers of yellow, because black still slightly shines through. My first try with Bambu Studio’s painting tool, so I consider it success nevertheless. Looks great, doesn’t it?