Works as it should and fits snuggly. I printed with silver PLA Silk+ and black PLA Basic. 

cr3Di

Bambu Lab door holder bracket for X1C and P1S

0.2mm layer, 2 walls, 15% infill

Printed a few of these from ABS. Looks great and fits the Bambu spools like a glove. Works well either in the AMS or in vacuum bags for storage. I did try with one 3D Jake spool that I happened to have as well, but it has slightly smaller space, so it’s a no go.

KYZ Design

KYZ FF2 High Airflow Spool Desiccant Holder

PLA/PETG/ASA/ABS/PC

Printed with PLA to the diamond effect plate. Fits well and I like this design more than the newer ones with the lid - but that’s just personal preference. I did slow down the initial layer to 20 and initial layer infill to 30, as I usually do with the effect plate to get good adhesion. There was a very small imperfection (due to the adhesion issues with the effect plate, I presume) near where the allen key clip attaches. So I might recommend slowing down the print speed, if you are using a smooth/effect plate. 

JS-3D

Screen Bezel with Allen keys holder V3 for P1P/P1S

0.16mm layer, 2 walls, 15% infill, detect thin walls

This just might be the best plate holder! I was looking for one that would be fixed into the printer and here it is. I was concerned if that 1,5 mm edge that my Ikea Kallax has next to my printer would be a problem, but no. The plate holder sits nicely despite the egde. Printed with PLA. I had to move the object just slighly further back on my print plate, because otherwise it would have been on top of that test strip that P1S does in the beginning. 