Printed great in PETG-CF

Really handy print

Good for calibrating flow.

Great for use with smooth plate, to prevent damage.

Works great

Handy little clips. Can be used with the AMS 2 Pro, but just make sure they're on the right side regarding the small notches in the back of the AMS. Otherwise they will touch those, which doesn't seem to be that bad, but I guess it's better not to.

The print itself is good. Only downside for me is that it makes it hard to remove the PTFE tube for nozzle cleaning, which is not ideal. It is quite hard to get on and off. Looks good and does what it says it should do, but not very practical in my opinion.

Just what I needed!

Really simple, low filament cost.

Front two installed, rear did not stay in place. Maybe not perfectly printed.

Very cute little keychain.

Nicely designed, hopefully the bees will like it.

Printed in PETG-CF. Worked really well. Print looks good and feels sturdy. Yet to install.

Little prone to breaking when pinched too hard. Maybe it's just my PLA. Other than that, works well.

Printed in ABS, makes sliding in the plate just that little bit easier.

Perfect for holding my pliers!

Printed a bunch, does what it needs to do!

Fits very well on the carbon rods, not too loose, not too tight. Holds the toolhead cover well out of the way when working on the toolhead.

Works great, very useful when printing PLA. Design looks good as well.

Perfect, fitment as well!