nice looking, strong, a bit challenging to remove the supports because i used auto settings for a better finish. thank you.

Great print!! My EDC! Thanks for putting both units on, it's very helpful to us Canadians.

This design is very practical and looks great! Fits AMS and AMS 2 Pro. Love it.

Useful design. Fits the manual caliper too. Can be sturdier. Hook to the board is not easy to attach. Hook to the holder is loose and the unhooking direction is the same direction as taking out the caliper. I'm looking forward to a new revision to address these issues.

Printed in PETG. Awesome design. I have been printing these since day 1. PLA gets soft and falls out from the spool after drying.

nice modification to the slider. very smooth sliding. I modified the slider knob for more ergonomic operation. I may upload the print profile later.

Fabulous design. Great way to display the swatches. Smooth sliding. I modified the slider knob for more ergonomic operation. I may upload the print profile later.

Great design. It works well. I printed it with PETG, it's sturdy enough. I haven't decided what colour to print for the Skadis boards, and I am planning to modify them so they will be bigger and merge the upper one with the lower one. The lower AMS does not sit too well when it's in the tilted position, the AMS becomes a little unstable and slightly lifted at the back. Also it can drop too suddenly when I let it slide by itself. Another thing is that it would be nice if theres something to hold the lid when it's open. Top AMS sits well and easy to operate. Great design overall. Thank you for sharing!!

I scaled it smaller to 11cm width. Redesigned the knock bar to have notches so it stays in place. The print profile is uploaded. I'm wondering why the print look different from the cover photo tho, but anyway it's a good looking design. Thank you.

Beautiful model! Great print profile. Reduced time and increased quality. Be extra careful removing the supports tho, I broke a tiny piece but glued it back. it's fine.

works perfectly! thank you!

great print

Very high quality design in both geometry and print setup. support is very easy to remove. print quality is amazing. I changed it to 0.16mm layer and added fuzzy skin (0.2/0.05mm).

This is the perfect size! thank you! I changed the settings to 2 walls, 8% gyroid, outer/inner, 0.16mm layer, 100mm/s outer wall speed, and used glue.

great print! I used glue on the plate to be extra secure.

Fantastic design. Needs a lot of patience assembling it, specifically aligning all the pins with the rail as mentioned in the instruction manual. great results. need some WD-40 and rotating for about 5min in both directions to smooth it out.

Printed them in PETG Translucent Clear with 0.1mm layer and 0.2mm for the double slot housing (too much overhang to print in 0.1mm). Turned out great!! Took me a while to figure out how to install them, coz there are two extra pieces. Thank you for the design!