Ended up like a wasps nest, poop piled up sticking to it and each other. still better than higher rated ones though as it’s a better shape and nothing escapes, I’ll try some tape on it (edit, tape 100% works no sticking now) . I think it’s a tricky one to avoid, hot sticky plastic just wants to stick to plastic.

nice snug fit, I sanded the little nodule that holds it closed to suit my preference, opens without issue.

Well I’ll be……….that was mesmerising. I watched the whole print, no issues. yeh I’m a noob. 10/10

To aid fitting I ran my craft knife in a scraping motion a couple of times down the corner of the side that snaps on, this worked a treat as I wasn’t having much luck beforehand it was super tight I just couldn’t get it over the corner. Once on though all the better for it. as a noob I’m loving all the mods for my A1, you fixed a niggling problem I noticed from just a few prints…..little pooper no more. awesome job.

I printed 3 off (bamboo A1, tabletop option) all came out perfectly, nice muscle detail and textures, a pleasure to paint. I used Scale Colour acrylics avoiding any washes or speed paints to avoid enhancing the fine print layers. They look great on the table. great work 👌