This print seems to be the answer the tube dragging on the glass top of the P2S! It should have been a factory part. Thank you for sharing this idea.

Printed very well in PETG HF and the fit is snug. Thank you.

This is going to be very useful for marking out connector spacing on electrical boxes!

I haven't used it yet but probably will next week. It printed out nicely.

I printed the 33-36 and the 16. Both turned out very well! Cool build, thanks for sharing!

This printed out perfectly in PETGHF. Thank you!

Printed really well with the fine mesh option and everything fits together beautifully! Thank you!

Printed perfectly and fits great!

Printed perfectly in PETG HF. I'll probably reprint in ABS once I've got a ventilation system set-up. Thanks for sharing the file!

Printed nicely in PETG HF on a P2S.Thanks!

Printed 3 of them in PETG-HF and they turned out nicely! The neighbor kid's parents are going to be annoyed with me. Haha

They're great. I'll be printing more! Thanks for sharing!

These work great. I like that I can pull them out easily because of the notch.

It turned out really well in PETG HF. Thank you for sharing the file.

I had to print the lids a second time on a separate plate using a Brim to keep the back storage box lid from lifting off the print bed. Turned out okay using a Brim. I used PETG that was 5% humidity and other than a little bit of stringing on the base layers of cross weave, it printed well.

It turned out very well.

The whistle is very loud and I wasn't blowing hard enough to make the slider work properly...

This turned out nicely with PLA. The outer and middle rings have to be meshed by laying one on top of the other or pushing the two together with a little force. I suspect that the gap between the teeth will loosen up somewhat with use.