Fits perfectly and it is significantly smaller than the original case

Fits perfectly, super satisfying to hear the snap. This addition make/ embossing so much easier to turn, nice!

The print didn’t turn out great, bottom of the “wires” turn out stringy. Use it emboss card and it turns out ok, overall a good idea to elevate your business cards.

Strudy & fits the roller perfectly.

The lowest part of the print that fit the wire is very tight, not too sure if it’s my settings issue. Overall a very nice cable management for my P2S AMS2 wires.

work as intended, easy to assemble, can’t wait to try it out.

works as intended. lines are very much visible not too sure if it due to my printer settings.

fast print and turn out great

works but not sure why the orange matte PLA didn’t show nicely.

look great in matte black, stable when pulling out the towel roll

fit nicely, just that the thin part holding photo seems very flimsy

flush to the side of P2S printer perfectly, join between 2 plates is tight as well. The latching point to the printer is kind of flimsy though.

unable to get the bin to snap in place, not sure what was the issue. printed in matte black pla. overall looks nice and the profile is pretty slim as well.

Cute, I scaled down too much can’t really the side design.

Fits nicely, note that for P2S it can only fit it on 1 side.

Perfect fit & love how slim it is

Printed 1 in matte pla , 1 inbasic pla both look and works great Just need sometime to get use to using it.

Printed in matte PLA and It works!!! nice tool

Printed out great, no issue with the hinges and button to release the case. Everything fits in nicely, love it.